Removal
1.

Move the shift lever to 4th gear.

2.

Remove the air duct and the air cleaner assembly.

(Refer to Engine Mechanical System - "Air Cleaner")

3.

Remove the battery and battery tray.

(Refer to Engine Electrical System - "Battery")

4.

Remove the control cable.

(1)

Remove the control cable from the control shaft after removing the snap pins (A).

(2)

Remove the control cable (B) from the bracket (C).

5.

Remove the gear boots (A) and then remove the shift lever knob (B) by rotating counter-clockwise.

6.

Remove the floor console assembly.

(Refer to Body - " Floor Console")

7.

Remove the select cable (A) from the shift lever after removing the snap pin.

8.

Remove the shift cable (B) after removing the clip (A).

9.

Remove the cable sockets (A) from the shift lever.

10.

Remove the crash pad and cowl cross bar.

(Refer to Body - "Cowl Cross Bar Assembly")

11.

Remove the heater unit.

(Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")

12.

Remove the retainer (A) after loosen the nut (B).

13.

Remove the control cable into the cabin room side.

Installation
1.

Install the cable retainer (A).

Tightening torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

2.

Install the heater unit.

(Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")

3.

Install the crash pad and cowl cross bar.

(Refer to Body - "Cowl Cross Bar Assembly")

4.

Install the control cable soket (A).

5.

Install the shift cable ( B) to the shift lever after intalling the snap pin (A).

6.

Insert the snap pin after installing the select cable (A) to the shift lever.

7.

Install the floor console assembly.

(Refer to Body - "Floor Console")

8.

Install the boots (A) to the console after Installing the knob (B) by rotating clockwise.

9.

Install the control cable.

(1)

Check that the shift lever and control shaft are placed in the "4th" position.

(2)

Install the control cable to the cable bracket.

(3)

After pulling the holder (A) in the direction of the "P", pull the lock (B) in the direction of the "F".

(4)

Push the lock (C) after installing the control cable to the control shaft.

(5)

Insert the snap pin (A).

10.

Install the battery and battery tray.

(Refer to Engine Electrical System - "Battery")

11.

Install the air cleaner assembly.

(Refer to Engine Mechanical System - "Air Cleaner")

Яндекс.Метрика