3.
Measure resistance between terminal "7" and terminal "8" of the ATM SOLENOID VALVE harness connector
a.
Specification: Approximately 4.35 ± 0.35 Ω (20℃)
Ignition "OFF"
Disconnect "A/T SOLENOID VALVE" connector
Measure resistance between terminal "7" and terminal "8" of the ATM SOLENOID VALVE harness connector
Specification: Approximately 4.35 ± 0.35 Ω (20℃)
Is resistance within specifications?
YES
Go to "CHECK PCM/TCM" as below
NO
Replace "PRESS CONTROL SOL VALVE" as necessary and go to "Verification Vehicle Repair" procedure
Connect scantool to data link connector(DLC)
Ignition "ON" & Engine "OFF".
Select A/T Solenoide valve Actuator test and Operate Actuator test.
Can you hear operating sound for "PRESS CONTROL SOL VALVE" Actuator Testing Function?
YES
Go to "Verification Vehicle Repair" procedure
NO
Replace PCM/TCM as necessary and Go to "Verificaiton Vehicle Repair" procedure
ACTUATOR TEST CONDITION
1. IG SWITCH ON
2. TRANSAXLE RANGE SWITCH is normal
3. P RANGE
4. Vehicle Speed 0km/h
5. Throttle position sensor＜ 1V
6. IDLE SWITCH ON
7. ENGINE RPM 0
