7.
Select "ENGINE (DIESEL)".
After replacing (an) injector(s), MUST input the injector data (7 digit) into the ECM.
Turn ignition switch OFF.
Disconnect the negative (-) battery cable.
Replace the injector with a new one according to the "REMOVAL" and "INSTALLATION" procedures.
Connect a scan tool to Data Link Connector (DLC).
Connect the negative (-) battery cable.
Turn ignition switch on.
Select "ENGINE (DIESEL)".
Select "INJECTOR SPECIFIC DATA".
Press "ENTER" key.
Input the injector data (7 digit) written on the top of each injector with function keys ([F1] ~ [F6]) and number keys.
Wait 10 seconds after displaying "WRITING COMPLETE", turn ignition switch OFF.
When "WRITING FAIL" is displayed on the scan tool, input injector data (7 digits) of each cylinder into a new ECM again starting from 7th step.
