3.
Monitor DTC(Diagnostics Trouble Code) on the scantool.
Vehicle uses 2WD(2 wheel drive) for driving at normal speed, but sometimes it uses 4WD (4 wheel drive) accordign to driving condition.
(cornering or acceleration)
EMC(Electric Magnetic Clutch) distributes proper torque to front wheel by controling amount of current inside EMC coil.
That time power pressing the multi plate clutch by apply cam is changed by a rate of EMC duty. after multi plate clutch start slip the force for acceletion at front/rear wheel is controlled at a range of 100:0 ~ 50 : 50.
ITM system has 4WD-LOCK function that can make driving force to 50:50 by compulsion according to driver's intention.
If the ITM-ECU decides that the clutch(EMC) and oil are over-heated (above specified value) for more than 1s, this code is set.When the failure is set there is no signal in the warning lamp, just ITM-ECU sets and stores this code.
Item | Detecting Condition | Possible Cause |
DTC Strategy | ● EMC shutdown plate and oil temp thresholds exceeded | ● Faulty EMC ● Faulty TCCU |
Enable Conditions | ● Message present 1.0 sec self clearing | |
Threshold Value | ● Thresholds exceeded for 1 second | |
Diagnostic Time | ● 1 sec | |
MIL on condition | ● 0.5 Sec | |
Fail Safe | ● ECU will not send current to the clutch coil |
Connect scantool to Data Link Connector(DLC).
Warm up the engine to normal operating temperature.
Monitor DTC(Diagnostics Trouble Code) on the scantool.
Is the same DTC displayed again?
▶ Check EMC, switch (4WD LOCK) condition.
▶ Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.
▶ Fault is intermittent caused by poor contact in the sensor’s and/or TCCU’s connector or was repaired and TCCU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace asnecessary and go to "Verification of vehicle Repair" procedure.
Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
Using scantool, Clear DTC.
Operate the vehicle within DTC Enable conditions in General information.
Are any DTCs present ?
▶ Go to the applicable troubleshooting procedure.
▶ System is performing to specification at this time.
