Install the rear upper arm (B), then install the mounting bolts (A) of the rear upper arm and the cross member.
Tightening torque Nm (kgf-m, lb-ft) :
98.1~117.7 (10.0~12.0, 72.3~86.8)
After checking the distance(453±10mm(17.83±0.39in)) between the wheel housing garnish (A) and the hub assembly (B) as shown in the illustration, tighten the mounting bolts and nuts of rear chassis part with specified torque.
Install the split pin (A) and the castle nut (B) to the rear upper arm ball joint (C).
Tightening torque Nm (kgf-m, lb-ft) :
78.5~88.3 (8.0~9.0, 57.9~65.1)
Install the rear cross member.
Support the rear cross member assembly (A) with the jack.
Install the rear cross member mounting bolts (A), nuts (B) and plate (C).
Tightening torque Nm (kgf-m, lb-ft) :
Bolts(A) : 156.9~176.5 (16~18, 115.7~130.2)
Nuts(B) : 156.9~176.5 (16~18, 115.7~130.2)
Install the rear cross member stay (A) and mounting bolt (B) and nut (C).
Tightening torque Nm (kgf-m, lb-ft) :
Bolt(B) : 68.6~88.3 (7~9, 50.6~65.1)
Nut(C) : 68.6~88.3 (7~9, 50.6~65.1)
After matching a match mark (C) on the rubber coupling (A) and rear differential companion (B), Install the propeller shaft mounting bolts (D).
Tightening torque Nm (kgf-m, lb-ft) :
49.0~68.6 (5~7, 36.2~50.6)
Install the wheel speed sensor (A) and the parking brake cable (B) to the rear axle carrier.
Tightening torque Nm (kgf-m, lb-ft) :
Wheel speed sensor (A) :
6.9~10.8 (0.7~1.1, 5.1~8.0)
Install the brake caliper (B), then tighten the brake caliper mounting bolts (A).
Tightening torque Nm (kgf-m, lb-ft) :
63.7~73.5 (6.5~7.5, 47.0~54.2)
Support the rear lower arm with a jack as shown in the illustration.
Install the rear shock absorber (A).
Tightening torque Nm (kgf-m, lb-ft) :
Bolt(B) : 137.3~156.9 (14~16, 101.3~115.7)
Nut(C) : 98.1~117.7 (10.0~12.0, 72.3~86.8)
Install the wheel and tire (A) to the rear hub (B).
Tightening torque Nm (kgf-m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
Be careful not to damage the hub bolts (C) when installing the rear wheel and tire (A).
