Component Inspection

■ Check auto cruise switch

1.

IG "OFF" and disconnect Cruise switch connector.

2.

Measure resistance between signal and ground terminals of Cruise switch connector with "RESUME" switch depressed.(Component side)

a.

Specification :

Item

Resistance(Ω)

RESUME switch

910 Ω ± 5% between signal and ground terminals

note
To view Flash content, you need to install the appropriate browser extension
3.

Is the measured reisistance within specification ?

YES

a.

Substitute with a known - good PCM and check for proper operation.

If the problem is corrected, replace PCM and go to "Verification of Vehicle Repair" procedure.

NO

a.

Substitute with a known - good auto cruise switch and check for proper operation.

If the problem is corrected, replace auto cruise switch and go to "Verification of Vehicle Repair" procedure.

caution

There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others

Яндекс.Метрика