4.
Is the measured resistance within specifications?
YES
a.
Go to "Check for open in harness" as follows.
NO
a.
Repair short to ground in harness, and go to "Verification of Vehicle Repair" procedure.
Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
YES
▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure
NO
▶ Go to " Signal Circuit Inspection " procedure.
■ Check short to ground in harness
IG "OFF"
Disconnect PCM connector and ABS(ESP) control module connector.
Measure resistance between vehicle speed input signal terminal of PCM harness connector and chassis ground.
Specification : Infinite
Is the measured resistance within specifications?
YES
Go to "Check for open in harness" as follows.
NO
Repair short to ground in harness, and go to "Verification of Vehicle Repair" procedure.
■ Check for open in harness
Ignition "OFF"
Disconnect PCM connector and ABS(ESP) control module connector.
Measure resistance between vehicle speed input signal terminal of PCM harness connector and wheel speed sensor output signal terminal of ABS(ESP) control module harness connector.
Specification : Approx. below 1Ω
Is the measured resistance within specifications?
YES
Go to " Check wheel speed sensor " procedure.
NO
Check open in harenss.
Repair or replace as necessary and then, go to " Verification of Vehicle Repair" procedure.
■ Check wheel speed sensor
IG "OFF"
Check open or short in wheel speed sensor (Refer to "C1203 Wheel speed sensor front-RH open/short")
Is the wheel speed sensor normal?
YES
Substitute with a known - good PCM/ ABS(ESP) control unit and check for proper operation.
If the problem is corrected, replace PCM/ ABS(ESP) control unit and go to "Verification of Vehicle Repair" procedure.
NO
Repair or replace it as necessary.
And then go to " Verification of Vehicle Repair" procedure.
There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by PCM. After testing PCM on the vehicle, use this function to reuse the PCM on the others
