Disconnect the battery negative cable and wait for at least three minutes.
Remove the ignition key from the vehicle.
Install the Seat Belt Pretensioner (BPT) with a bolt.
Tightening torque
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Install the upper and lower anchor bolts.
Tightening torque (Seat Belt Anchor Bolt)
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Install the center pillar trim.
Install the door scuff trim.
Reconnect the battery negative cable.
After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
