3.
Disconnect the ECM connector (A) and unfasten the mounting bolts under the instrument panel.
After replacing an ECM, MUST input the injector data (7 digit) of each cylinder into a new ECM. In the case of the vehicle eguipped with immobilizer, perform "KEY TEACHING" procedure with injector data input. (Refer to "BE" group in this Shop Manual)
Turn ignition switch OFF.
Remove the battery negative (-) cable from the battery.
Disconnect the ECM connector (A) and unfasten the mounting bolts under the instrument panel.
Install a new ECM according to the reverse order of step 1, 2, and 3.
ECM mounting bolts/nuts : 0.8 ~ 1.2kgf·m (7.8 ~ 11.8 N·m, 5.8 ~ 8.6lbf·ft)
Connect a scan tool to Data Link Connector (DLC).
Connect the negative (-) battery cable.
Turn ignition switch on.
Proceed "INJECTOR SPECIFIC DATA" procedure.
Select "ENGINE (DIESEL)"
Select "INJECTOR SPECFIC DATA".
Press "ENTER" key.
Input the injector data (7 digit) written on the top of each injector with function keys ([F1] ~ [F6]) and number keys.
Wait 10 seconds after displaying "WRITING COMPLETE", turn ignition switch OFF.
When "WRITING FAIL" is displayed on the scan tool, input injector data (7 digits) of each cylinder into a new ECM again starting from 7th step.
