2.
Remove the pinion assembly mounting bolts (7EA) and then remove the pinion assembly(A).
note
This assembly can be removed with a propella shaft assembly in 'REMOVAL' step.
Drain the transfer oil through drain plug hole.
Remove the pinion assembly mounting bolts (7EA) and then remove the pinion assembly(A).
This assembly can be removed with a propella shaft assembly in 'REMOVAL' step.
Remove the dust cover(A).
Remove the transfer cover(A).
Remove the transfer drive gear assembly(A) and the hypoid gear shaft assembly(B) from the trasfer housing.
Remove the oil seal(A)(47452-39000, transfer drive gear left hand side).
When reassembling the transfer, be sure to always replace the oil seal(47452-39000) with new part.
Remove the oil seal(47352-39300) inside the transfer cover.
Using a sliding hammer, remove the taper roller bearing outer races(C) from the transfer cover(A) and housing(B).
Remove the oil seal(A) from the transfer cover.
When reassembling the transfer, be sure to always replace the oil seal(47350-39300) with new part.
