1.
If the front bearing needs replacing, remove the pulley(A) lock nut(C) with an impact wrench(B).
If the front bearing needs replacing, remove the pulley(A) lock nut(C) with an impact wrench(B).
Remove the generator cover(A) after removing the three nuts(B).
Remove the brush holder(A).
Remove the four screws, the rectifier(B) and the rubber seal(C).
Remove the four nuts(A) and insulators(B).
Remvoe the rear bracket assembly(A) and washer(B).
Remove the rotor(A) fron the stator and front frame assembly(B).
