3.
Is the measured resistance within specification ?
YES
a.
Go to "Check open in harness" as follows
NO
a.
Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
Many malfunctions in the electrical system are caused by poor harness and terminals.
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
YES
▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure
NO
▶ Go to " Power Circuit Inspection " procedure
■ Check voltage
IG "OFF" & Disconnect OCV(B1) connector.
IG "ON" & ENG "OFF".
Measure voltage between power terminal of OCV(B1) harness connector and chassis ground.
Specification : B+
Is the measured voltage within specification ?
YES
▶ Go to "Control Circuit Inspection" procedure.
NO
▶ Check fuse between Main Relay and OCV is open or not installed.
▶ Check open in power circuit between Main Relay and OCV power circuit.
▶ Repair or repalce as necessary and then go to "Verification of Vehicle Repair" procedure.
■ Check short to ground in harness
IG "OFF" and disconnect OCV connector.
Measure resistance between control terminal of OCV harness connector and chassis ground.
pecification : Infinite
Is the measured resistance within specification ?
YES
Go to "Check open in harness" as follows
NO
Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
■ Check open in harness
IG "OFF" and disconnect OCV and PCM connector.
Measure resistance between control terminal of OCV harness connector and OCV control terminal of PCM harness connector.
Specification : Approx. below 1Ω
Is the measured resistance within specification ?
YES
Go to "Component Inspection" procedure.
NO
Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
