4.
Inspect opearating status of ESP(HSV) valve #2 with Actuation Test.
Specification : It's normal if operating sound is heard.
Fig 1) Test Condition : Ignition "ON" & Engine "OFF".
Ex) Actuation Test on ESP(HSV) valve #2
Connect scantool to Data Link Connector(DLC)
Ignition "ON" & Engine "OFF".
Select the "Actuation Test" mode on the scantool.
Inspect opearating status of ESP(HSV) valve #2 with Actuation Test.
Specification : It's normal if operating sound is heard.
Fig 1) Test Condition : Ignition "ON" & Engine "OFF".
Ex) Actuation Test on ESP(HSV) valve #2
Does a ESP(HSV) valve #2 operate normally?
 | ▶ Fault is intermittent caused by faulty valve or was repaired and HECU memory was not cleared. Go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Component Inspection" procedure. |
