1.
Apply gear oil on the oil seal contacting surface (B) of transaxle case and the driveshaft splines (A).
Apply gear oil on the oil seal contacting surface (B) of transaxle case and the driveshaft splines (A).
Before installing the driveshaft (C), set the opening side of the circlip (D) facing downward.
After installation, check that the driveshaft (C) cannot be removed by hand.
Install the inner shaft bearing bracket assembly (A) and then tighten the mounting bolts.
Tightening torque Nm (kgf-m, lb-ft) :
49.0~68.6 (5~7, 36.2~50.6)
Install the dust cover (A). (RH side)
Tightening torque Nm (kgf-m, lb-ft) :
7.8~11.8 (0.8~1.2, 5.8~8.7)
Install the driveshaft to the axle hub.
Install the lower arm mounting bolt (B) and the split pin to the knuckle (A).
Tightening torque Nm (kgf-m, lb-ft) :
98.1~117.7 (10~12, 72.3~86.8)
Install the tie rod end ball joint (C) to the knuckle (D).
Install the castle nut (B) and the split pin (A).
Tightening torque Nm (kgf-m, lb-ft) :
23.5~33.3 (2.4~3.4, 17.4~24.6)
Install the brake caliper (B) and then tighten the mounting bolts (A).
Tightening torque Nm (kgf-m, lb-ft) :
78.5~98.1 (8~10, 57.9~72.3)
Install the washer (C), castle nut (B) and split pin (A) to the front hub assembly.
Tightening torque Nm (kgf-m, lb-ft) :
196.1~255.0 (20~26, 144.7~188.1)
The washer (B) should be assembled with convex surface outward when installing the castle nut (A) and split pin (C).
Install the wheel and tire (A) to the front hub (B).
Tightening torque Nm (kgf-m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
Be careful not to damage the hub bolts (C) when installing the front wheel and tire (A).
