2.
Remove the front wheel and tire (A) from the front hub (B).
caution
Be careful not to damage to the hub bolts (C) when removing the front wheel and tire (A).
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
Remove the front wheel and tire (A) from the front hub (B).
Be careful not to damage to the hub bolts (C) when removing the front wheel and tire (A).
Remove the split pin (A), then remove castle nut (B) and washer (C) from the front hub under applying the brake.
Remove the brake caliper mounting bolts (A), and then place the brake caliper assembly (B) with wire.
Remove the tie rod end ball joint from the knuckle.
Remove the split pin (A).
Remove the castle nut (B).
Disconnect the ball joint (C) from knuckle (D) using the special tool (09568-4A000).
Apply a few drops of oil to the special tool. (Boot contact part)
Remove the wheel speed sensor (B), the strut lower mounting bolt (C) and the lower arm mounting bolt (D) from the knuckle (A).
Remove the hub and knuckle assembly.
Be careful not to damage the boot and rotor teeth.
