4.
Monitor the "SENSOR ANGLE" Parameter on the Scantool.
Specification : Below - 0.4 ± 2 DEG (Unloaded Vehicle Condition)
Park the vehicle in a flat land and remove all the loads from the vehicle.
Connect scantool to Data Link Connector(DLC).
Monitor DTC(Diagnostics Trouble Code) on the scantool.
Monitor the "SENSOR ANGLE" Parameter on the Scantool.
Specification : Below - 0.4 ± 2 DEG (Unloaded Vehicle Condition)
Is parameter displayed within the Specification?
 | ▶ This is a intermittent problem caused by poor contact of component or Control Unit. ▶ Thoroughly check the looseness, poor connection, bent, corrison, contamination, deformation or damage of connector. ▶ Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure. ▶ After its repair done, Perform the lamp actuation by GDS in order to verify its normal operation. |
 | ▶ Go to "Inspection and Repair" procedure. |
