Vehilcles have many options in one type of ECM. So automatic recognition function is applied. The options that can be recognized are MT/AT, 2/4WD, DPF, etc). When a ECM is installed to vehicle, these options recognition are performed by the ECM automatically as checking whether ground line is grounded or opened every IG KEY ON process.
If this recognition is not fulfilled well or any error occurs during the process, engine power generation is not sufficient and glow lamp on cluster blinks.
If a system is intalled, the ECM connector is grounded.
Else is opened (no wire exists).
P1591 is set when ECM is recognized as no DPF vehicle in spite of DPF or the opposite case.
Item | Detecting Condition | Possible Cause | ||
DTC Strategy |
•
Software monitoring |
•
ECM component failure
•
DPF recognition circuit | ||
Enable Conditions |
•
IG KEY "ON" | |||
Threshold value |
•
Difference signal is low or autumatic recognition ground terminal is not good. | |||
Diagnosis Time |
•
1sec. | |||
Fail Safe | Fuel cut | NO |
•
- | |
EGR Off | NO | |||
Fuel Limit | NO | |||
MIL | OFF | |||
