Component Inspection
■ Check Parking Position Switch
1.

IG KEY OFF.

2.

Disconnect Parking Position switch connector.

3.

Measure resistance between one and the other connector when parking postion switch ON and OFF.

Specification : Measurement 1 : Infinite (∞), Measurement 2 : About below 1Ω

4.

Is the measured resistance within specification ?

▶ Check poor connection between harness connector and Parking Postion switch or Smartkey Module

: Thoroughly check the looseness, poor connection, bent, corrison, contamination, deformation or damage of connector.

Repair or replace as necessary and then, go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good parking position switch and check for proper operation.

If the problem is corrected, replace parking postion switch and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика