4.
Remove the valve (C) after removing the installation bolt.
Turn the ignition switch OFF.
Disconnect the EGR cooler bypass solenoid valve connector.
Measure resistance between the valve terminals 1 and 2.
Check that the resistance is within the specification.
Specification: Refer to “Specification” section.
Turn the ignition switch OFF and disconnect the battery (-) cable.
Disconnect the EGR cooler bypass solenoid valve connector (A).
Disconnect the vacuum hose (B) from the EGR cooler bypass solenoid valve.
Remove the valve (C) after removing the installation bolt.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Installation is reverse of removal.
EGR cooler bypass solenoid valve installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)
