Disconnect 2P-connector from a ignition lock switch.
Disconnect the ignition lock switch. (if you can install a tester with the switch fixed, this step can be omissible)
Check for continuity between terminals. (refer to the table below)
Clutch pedal position | Ignition lock switch | Continuity |
Released | Released | NO |
Pressed | Pressed | YES |
If there is difference between what tested and the table above, replace the ignition lock switch with a new one.
If not, install the ignition lock switch and adjust the clutch pedal.
TORQUE :
8~10Nm (0.8~1.0kgf.m, 5.8~7.2lb-ft)
