2.
Remove the overhead console then remove the sun roof motor mounting screws (3EA). And then remove the sunroof motor after disconnecting the connector (10 Pin).
Disconnect the negative (-) battery terminal.
Remove the overhead console then remove the sun roof motor mounting screws (3EA). And then remove the sunroof motor after disconnecting the connector (10 Pin).
Ground the terminals as below table, and check that the sunroof unit operates as below table.
Make these input tests at the connector
if any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the sunroof motor must be faulty; replace it.
Terminal | Test condition | Test : Desired result |
3 | IG2 ON | Check for voltage to ground : There should be battery voltage |
1 | Under all conditions | Check for continuity to ground : There should be continuity. |
6 | Under all conditions | Check for voltage to ground : There should be battery voltage. |
Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the sunroof, you have to reset your sunroof system as follows :
Turn the ignition key to the ON position and then close the sunroof completely.
Release the sunroof control lever.
Press and hold the CLOSE button for more than 10 seconds until the sunroof closed and it has moved slightly.
Release the sunroof control lever.
Press and hold the CLOSE button once again within 5 seconds until the sunroof do as follows;
Tilt → Slide Open → Slide Close
Then release the lever.
Reset procedure of panorama system is finished.
