1.
Remove the quadrant inner cover (A).
Take care not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the quadrant inner cover (A).
Remove the inside handle cover (A).
Loosen the door trim (D) mounting screws. Release the clips that hold the door trim, then remove the door trim by pulling it upward. Disconnect the power window switch connector (A), power mirror connector (B), and door courtesy lamp connector (C).
Installation is the reverse of removal.
Make sure of connectors is plugged in properly and each rod is connected securely.
Make sure the door lock and opens properly.
Remove the front door trim.
Carefully move the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Adjust the position of the glass as necessary.
Remove the front door trim.
Loosen the inside handle (A) mounting screw.
Disconnect the lock cable (A) and inside handle cable (B).
Remove the inside handle(C).
Installation is the reverse of removal.
Make sure the door locks and open properly.
Remove the front door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
Remove the door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Remove the following parts.
Front door trim.
Window glass.
Outside handle.
Loosen the outside handle base mounting screw (A).
Loosen the module (A) mounting bolts and latch mounting screws.
Disconnect the door module wiring harness (A), then remove the module assembly (B).
Installation is the reverse of removal.
Make sure the connector are plugged in properly and each rod is connected securely.
Make sure the door locks and opens properly.
Remove the following parts.
Front door trim.
Window glass.
Inside handle.
Door module.
Remove the latch assembly (A).
Installation is the reverse the removal.
Make sure the door locks and opens properly.
Loosen the mounting bolt, then remove the key holder (A).
Remove the outside handle (A).
Installation is the reverse of removal.
Remove the front door trim.
Remove the door module.
Loosen the mounting bolt, then remove the rear checker (A).
Installation is the reverse the removal.
Loosen the mounting screw, then remove the door belt weatherstrip (A).
Installation is the reverse of removal.
Loosen the checker mounting bolts.
Detach the clips, then remove the weatherstrip(A).
Installation is the reverse of removal.
When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
Remove the front door trim.
Remove the power window switch (A).
Installation is the reverse the removal.
