1.
Remove the inside handle cover (A).
Take care not to scratch the door trim and other parts.
Put on gloves to protect your hands.
Remove the inside handle cover (A).
Loosen the door trim (B) mounting screws. Release the clips that hold the door trim, then remove the door trim by pulling it upward. Disconnect the power window switch connector (A).
Installation is the reverse of removal.
Make sure of connectors is plugged in properly and each rod is connected securely.
Make sure the door locks and opens properly.
Remove the following parts.
Rear door trim.
Window glass.
Outside handle.
Loosen the outside handle base mounting screw (A).
Loosen the module (A) mounting bolts and latch mounting screws.
Disconnect the door module wiring harness (A), then remove the module assembly (B).
Installation is the reverse of removal.
Make sure the connector are plugged in properly and each rod is connected securely.
Make sure the door locks and opens properly.
Put on gloves to protect your hands.
Remove the rear door trim.
Loosen the screws and bolt, then remove the quarter glass (A).
Take care not to drop to glass and scratch the glass surface.
Carefully move the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Adjust the position of the glass as necessary.
Remove the rear door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
Roll the glass up down to see if it move freely without binding.
Remove the door trim.
Loosen the mounting bolt, then remove the handle cover (A).
Remove the outside handle (A).
Installation is the reverse of removal.
Remove the following parts.
Front door trim.
Window glass.
Inside handle.
Outside handle.
Remove the module assembly.
Remove the latch assembly (B).
Installation is the reverse the removal.
Make sure the door locks and opens properly.
Remove the front door trim.
Loosen the inside handle (A) mounting screw. Push the inside handle rearward to disconnect.
Disconnect the lock cable (A) and inside connect cable (B).
Installation is the reverse of removal.
Make sure the door locks and opens properly.
Loosen the mounting screw, then remove the door belt weatherstrip (A).
Installation is the reverse of removal.
Loosen the checker mounting bolts.
Detach the clips, then remove the weatherstrip(A).
Installation is the reverse the removal.
Remove the rear door trim.
After disconnecting the connector (A), remove the power window motor (B).
Installation is the reverse of removal.
