8492258

1.

Connect scantool with Diagnostic Connector.

2.

Engine 'ON" and Turn On the auto head light system.

3.

Erase the DTC with Scantool.

4.

Is it possible to erase the DTC with Scantool ?

▶ Check head lamp movement with actuation test and then, go to 'Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good "AHLS-ECM(SENSOR)" and check for proper operation. If the problem is corrected, replace "AHLS-ECM(SENSOR)" and then go to "Verification Vehicle Repair" procedure.

▶ After its repair done, Perform the lamp actuation by GDS in order to verify its normal operation.

caution

Perform Vehicle Selection and Level Initialization with scantool if AHLS ECM is repalce. (Auto Levelling Sensor)

Fig.1) Vehicle Selection and Leveling Initialization 1.

Fig.2) Vehicle Selection and Leveling Initialization 2.

Fig.3) Vehicle Selection and Level Initialization 3.

Fig.4) Vehicle Selection and Level Initialization 4.