Remove the front door trim.

(Refer to the BD group - "Front door")

Remove the front door module.

(Refer to the BD group - "Front door")

Disconnect the connectors from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the rear door trim panel.

(Refer to the BD group - "Rear door")

Remove the rear door module.

(Refer to the BD group - "Rear door")

Disconnect the connectors from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the tailgate trim.

(Refer to the BD group - "Tailgate")

Disconnect the 4P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the front door trim.

(Refer to the BD group - "Front door")

Remove the front door module.

(Refer to the BD group - "Front door")

Disconnect the connectors from the actuator.

Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.

Remove the rear door trim panel.

(Refer to the BD group - "Rear door")

Remove the rear door module.

(Refer to the BD group - "Rear door")

Disconnect the connectors from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Remove the tailgate trim.

(Refer to the BD group - "Tailgate")

Disconnect the 4P connector from the actuator.

Check for continuity between the terminals in each switch position according to the table.