Injector Specific Data Input
caution

After replacing injector, MUST input the injector specific data (7 digit) of each cylinder into ECM with the GDS.

note
1.

Turn ignition switch OFF.

2.

Connect the GDS to Data Link Connector (DLC).

3.

Turn ignition switch ON.

4.

Select "Vehicle, Model year, Engine, System".

5.

Select "Vehicle S/W Management".

6.

Select "injector Specific Data".

7.

Perform the procedure in accordance with the message.

8.

After selecting "OK" on the "Writing success" message, turn ignition switch OFF.

9.

In about 10 seconds, turn ignition switch ON and recheck the injector specific data memorized in the ECM.

note

In case of failure, input the injector specific data (7 digits) into ECM again.

Яндекс.Метрика