2.
Disconnect the crankshaft position sensor connector (A).
Check signal waveform of CMPS and CKPS using the GDS.
Specification: Refer to "Signal Wave Form" section.
Turn the ignition switch OFF and disconnect the battery (-) cable.
Disconnect the crankshaft position sensor connector (A).
Remove the start motor (Refer to "Start System" in EE group.)
Remove the dust cover (A).
Remove the crankshaft position sensor (B) after removing the installation screw.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
When you install the dust cover, stick it to the block. And then must check the sensor cable whether seperating.
Installation is reverse of removal.
