1.
Using the hexagon wrench, turn the tensioner counterclockwise and loosen. Then remove the drive belt (A).
Using the hexagon wrench, turn the tensioner counterclockwise and loosen. Then remove the drive belt (A).
Drain the engine oil, and then remove the oil filter&cooler assembly (A).
Drain the engine oil in the oil filter before removing the oil filter&cooler assembly.
Remove the air compressor (A). (Refer to HA group)
Remove the lower oil pan (A).
Remove the upper oil pan (A).
When removing the upper or lower oil pan, use the SST (09215-3C000) in order not to damage the surface between the cylinder block and the oil pan.
Insert the SST between the oil pan and cylinder block (or upper oil pan) by tapping it with a plastic hammer in the direction of ① arrow.
After tapping the SST with a plastic hammer along the direction of ② arrow around more than 2/3 edge of the oil pan, remove it from cylinder block (or upper oil pan).
Do not turn over the SST abruptly without tapping. It may be result in damage of the SST.
Remove the balance shaft & oil pump module (A).
Do not disassemble and reassemble the balance shaft & oil pump module as it is supplied with assembly.
