4.
Driving above 20 Km/h.
Specification : Increasing Gradually
Fig.1) "P,N" range
Fig.2) "D" range 2nd gear
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & Engine "ON".
Selet "Currnet Data"mode and monitor "Vehicle Speed Sensor (Output speed sensor_PG-B)" parameter.
Driving above 20 Km/h.
Specification : Increasing Gradually
Fig.1) "P,N" range
Fig.2) "D" range 2nd gear
Is measured "Vehicle Speed Sensor(Output speed sensor)" value within specificon?
 | ▶ Fault is intermittent caused by poor contact between PCM and Sensor, and DTC was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "Terminal and Connector Inspection" procedure. |
