Monitor GDS Data
1.

Place TPMS Exiter within 10 cm of the tire's sensor which will be measured.

2.

Check a sensor's ID out of sensor's information.

Measuring method : Refer to No.1 Measurement

NO.1) A method of checking a sensor ID with TPMS Exciter　TPMS Exiter within 10 cm of the tire's sensor which 　　　　　　　　　　　　　　　　　　　　　　　　　　　will be measured

Fig.1) Data displayed by TPMS ECU

3.

Is parameter within specifications?

▶ Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.

▶ Go to "Verification of vehicle Repair" procedure.

▶ If the sensor's option is LOW, Re-register the sensor and transfer into HIGH B68with TPMS Exciter and check if there is no DTC left.

▶ If the sensor's option doesn't change, Substitue with a known-good TPMS sensor and check for proper operation.

If problem is corrected, replace TPMS sensor and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика