4.
Remove the washer hose (A) and the washer motor connector (B).
Disconnect the negative (-) battery terminal.
Remove the front bumper cover.
(Refer to the BD group - "Front bumper")
Remove the head lamp washer nozzle after loosening bolts.
Remove the washer hose (A) and the washer motor connector (B).
Disconnect the washer fluid level sensor switch connector (A).
Remove the washer reservoir after removing 3 bolts.
Installation is the reverse of removal.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
If they are abnormal, replace the washer motor.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
Disconnect the negative(-) battery terminal.
Drain the washer fluid less than 650 cc.
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continity when the folat is up.
If the continuity is not as specified, replace the washer fluid level switch
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
Connect positive (-) battery cables to terminal 1 and negative (+) battery cables to terminal 2 respectively.
Check that the motor operates normally and the washer motor runs and water sprays from the head lamp washer nozzles.
If they are abnormal, replace the head lamp washer motor.
