2.
Loosen the mounting bolts (2EA) and a nut of head lamp. Remove the head lamp assembly after disconnecting the lamp connectors.
note
Take care that retaining clip (A) is not to be damaged.
Disconnect the negative (-) battery terminal.
Loosen the mounting bolts (2EA) and a nut of head lamp. Remove the head lamp assembly after disconnecting the lamp connectors.
Take care that retaining clip (A) is not to be damaged.
Remove the head lamp bulb.
Installation is the reverse of removal.
Turn the head lamp switch off.
Disconnect the power connector from the lamp.
Remove the lamp assembly.
Remove the dust cover after loosening the screws (3EA).
Remove the bulb and ignitor (B) from the lamp assembly after disconnecting the connector (A).
Installation is the reverse of removal.
Turn the head lamp switch off to avoid high voltage
Be careful not to damage the bulb and use genuine bulbs only
Do not apply excessive force and fit it correctly.
Confirm the bulb locking
Turn the head lamp switch off.
Disconnect the power connector from the lamp.
Remove the head lamp assembly.
Remove the ballast (A) after loosening the screws (3EA).
Installation is the reverse of removal.
Turn the head lamp switch off to avoid high voltage.
HID lamp shall not be used on other cars.(Fire may occur.)
Fire may occur when HID lamp initially lights due to the fact that arc-discharge generates high voltage (max. 20,000V) and high current (12-13A), and are different from the halogen lamp specification.
Install the dust cover after confirming the locking state between bulb and bulb holder.
When testing the HID head lamp, turn the power on or off with switch between power supply and lamp because of high voltage.
Do not operate the head lamp switch with the bulb not installed, because it generates spark momently.
