Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Remove the ignition key from the vehicle.
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque
: 0.7 ~ 0.9 kgf.m (6.8 ~ 9.2 Nm, 5.0 ~ 6.8 lb.ft)
Use new mounting bolts when replacing the SRSCM after a collision.
Connect the SRSCM harness connector.
Install the heater ducts and floor console. (Refer to BD group)
Connect the DAB, PAB, SAB, CAB and BPT connectors.
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able to expanse if mechanic moves the SRSCM on vehicle during IGN ON state. For this reason, turn the IGN OFF surely and then remove the SRSCM from vehicle.
