4.
Remove the fixing clip (B), and then pull the sensor from the water temperature control assembly.
caution
●
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
Turn the ignition switch OFF.
Disconnect the ECTS connector.
Remove the ECTS (Refer to "Removal").
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the air cleaner assembly (Refer to "Intake And Exhaust System" in EM group).
Disconnect the engine coolant temperature sensor connector (A).
Remove the fixing clip (B), and then pull the sensor from the water temperature control assembly.
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
Supplement the engine coolant (Refer to “Cooling System” in EM group).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine coolant to the O-ring.
Insert the sensor in the installation hole and be careful not to damage when installation.
Installation is reverse of removal.
