Adjust the shift cable.

Refill engine with engine oil.

Refill transaxle with fluid.

Clean the battery posts and cable terminals with sandpaper and assemble them, then apply grease to prevent corrosion.

Inspect for fuel leakage.

If the engine does not run immediately after assembling the fuel line, remove trapped air and be pressurized in the fuel line by operating the low pressure fuel pump using the GDS.

Check for fuel leakage at any point in the fuel lines.

Refill radiator with engine coolant.

Bleed air from the cooling system.

Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)

Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.

Put radiator cap on tightly, then run the engine again and check for leaks.