2.
Remove the rear wheel and tire (A) from the rear hub (B).
caution
Be careful not to damage to the hub bolts (C) when removing the rear wheel and tire (A).
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
Remove the rear wheel and tire (A) from the rear hub (B).
Be careful not to damage to the hub bolts (C) when removing the rear wheel and tire (A).
Support the rear lower arm with a jack as shown in the illustration.
Remove the rear shock absorber (A).
Remove the brake caliper mounting bolts (A), and then place the brake caliper assembly (B) with wire as shown in the illustration.
Remove the wheel speed sensor (A) and the parking brake cable (B) from the rear axle carrier.
After making a match mark (C) on the rubber coupling (A) and rear differential companion (B), remove the propeller shaft mounting bolts (D).
Support the rear cross member assembly (A) with the jack.
Remove the rear cross member stay (A) and mounting bolt (B) and nut (C).
Remove the rear cross member mounting bolts (A), nuts (B) and plate (C).
Remove the rear cross member.
Remove the rear stabilizer bar link (A) and bracket (B).
Remove the rear stabilizer bar.
