4.
Monitor the "Steering Angle Sensor" parameters on the Scantool.
Fig 1) Test Condition : Ignition "ON" & Engine "ON".
Normal Data
Connect scantool to Data Link Connector(DLC)
Ignition "ON" & Engine "ON".
Turn the steering wheel to the left or right.
Monitor the "Steering Angle Sensor" parameters on the Scantool.
Fig 1) Test Condition : Ignition "ON" & Engine "ON".
Normal Data
Whenever steering wheel is turned, is the steering sensor’s scantool data changed?
Connect scantool to Data Link Connector(DLC).
Ignition "ON" & Engine "ON".
Keep the steering wheel in ceter position.
Monitor the "STEERING ANGLE SNSR" parameters on the Scantool.
Specification : Approx. 0 DEG
Is parameter displayed within specifications?
| ▶ Go to "Terminal and Connector Inspection" procedure. |
 | ▶ Go to next step. (6) |
▶ Go to "Terminal and Connector Inspection" procedure.
Perform steering angle sensor calibration.
Ignition "ON" & Engine "OFF".
Connect scantool to Data Link Connector(DLC).
Go in Elec. Power Steering system.
Perform ASP calibration. (figure 2).
Go to "Component Inspection" Precedure.
