8826210

Electrical systems consist of a lot of harness and connectors, poor connection of terminals can cause various problems and damage of component.

Perform checking procedure as follows.

(1)

Check damage of harness and terminals : Check terminals for contact resistance, corrosion and deformation.

(2)

Check connecting condition of ECM and component connector : Check terminal separation, damage of locking device and connecting condition between terminal and wiring.

note

Disconnect the pin which requires checking at male connector and insert it to the terminal at female connector for checking connecting condition. (After checking, reconnect the pin at correct position.)

Is the problem found?

	▶ Repair the trouble causing part and go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Injector Circuit Inspection".

Check resistance between 'High' terminal of 'INJECTOR #' harness connector and 'High' terminal of ECM harness connector.

Specification : Continuity (Below 1.0Ω)

note

To view Flash content, you need to install the appropriate browser extension

Is the measured value within specification?

	▶ Go to "Control Circuit Inspection".
	▶ Repair open between 'High' terminal of abnormal 'INJECTOR' harness connector and 'High' terminal of ECM harness connector, and go to "Verification of Vehicle Repair" procedure.

Check resistance between 'Low' terminal of 'INJECTOR #' harness connector and 'Low' terminal of ECM harness connector.

Specification : Continuity (Below 1.0Ω)

note

To view Flash content, you need to install the appropriate browser extension

Is the measured value within specification?

	▶ Go to "Component Inspection" procedure.
	▶ Repair open between 'Low' terminal of abnormal 'INJECTOR' harness connector and 'Low' terminal of ECM harness connector, and go to "Verification of Vehicle Repair" procedure.