Component Inspection
■ Check lambda sensor heater resistance
1.

IG key OFF.

2.

Disconnect lambda sensor connector.

3.

Check resistance between heater power ('Engine control relay 'ON') terminal and 'Heating' terminal ('LAMBDA SENSOR' component connector).

Specification : 2.4 ~ 4.0Ω (20℃)

note
To view Flash content, you need to install the appropriate browser extension
4.

Is the measured value within specification?

▶ Go to "Verification of Vehicle Repair".

▶ Replace lambda sensor and go to "Verification of Vehicle Repair".

note

In case of replacing lambda sensor, perform the "COMPONENT CHANGE ROUTINE" procedure with scan tool. If the "COMPONENT CHANGE ROUTINE" procedure has not completed until automatic learning completed, it may cause vehicle performance and exhaust gas problem.

Яндекс.Метрика