3.
Remove the fuel pump service cover (A).
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
Remove the rear seat (Refer to “Seat” in BD group).
Remove the fuel pump service cover (A).
Disconnect the fuel pump connector (A).
Disconnect the fuel feed tube quick connector (B) and the suction tube quick-connector (C).
Remove the plate cover (D) by using the special service tool [SST No.: 09310-3P100], and then remove the fuel pump from the fuel tank.
Installation is reverse of removal.
Fuel pump plate cover tightening:
58.9 ~ 68.7 N.m (6.0 ~ 7.0 kgf.m, 43.4 ~ 50.6 lb-ft)
Be careful of fuel pump direction when installing (Refer to the groove in the fuel tank).
