1.
Drill out all spotwelds and MIG plug welds, grind away MIG lap welds attaching the fender apron inner panel.
note
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Drill out all spotwelds and MIG plug welds, grind away MIG lap welds attaching the fender apron inner panel.
When spotwelded portions are not apparent, remove paint with a rotary wire brush.
Remove the fender apron inner panel.
Prepare all surfaces to be welded.
After removing, apply the welding primer.
Drill the holes in the flange of the replacement new fender apron inner panel for MIG plug welding.
Fit and clamp the new fender apron inner panel in place.
Measure each measurement point (Refer to the Body Dimensions) and correct the installation position.
MIG plug weld all holes and MIG lap weld the seams.
Clean and prepare all welds, and remove all residues.
Apply an anti-corrosion agent as required (Refer to the Corrosion Protection).
Prepare the exterior surfaces for priming using wax and grease remover.
Apply the correct seam sealer to all joints carefully (Refer to the Body Sealing Location).
