P0830 is set when no clutch switch signal change is detected 1). within 2 sec. after shifting gear during driving. 2). while gear shifts 4 times at above 10Km/h and 1000rpm. This code is due to 1) clutch switch component failure or 2) open or short in circuit 3) improper height of clutch pedal.
※ ECM recognize ingaged gear with rpm and vehicle speed sensor signal.
Item | Detecting Condition | Possible Cause | ||
DTC Strategy |
•
Signal monitoring |
•
Clutch S/W circuit
•
Clutch S/W component
•
Clutch S/W pedal hight | ||
Enable Conditions |
•
IG KEY "ON" | |||
Threshold Value |
•
No clutch switch signal change is detected until gear shifted 4 times at above 10Km/h and 1500rpm | |||
Diagnostic Time |
•
immediately | |||
Fail Safe | Fuel Cut | NO | ||
EGR Off | NO | |||
Fuel Limit | NO | |||
MIL | NO | |||
