3.
Has a problem been found?
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to next procedure. |
Many malfunctions in the electrical system are caused by poor connection. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.
Has a problem been found?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to next procedure. |
Ignition "OFF"
Disconnect evaporator sensor and A/C control Module main harness connector.
Measure resistance between Signal(+) terminal of evaporator sensor harness connector and chassis ground
Specification : Infinity Ω
Is the measured resistance within specification?
| ▶ Substitute with a known-good evaporator sensor and check for proper operation. If the problem is corrected, replace evaporator sensor and then go to "Verification of Vehicle Repair" procedure. ▶ Substitute with a known-good A/C control Module and check for proper operation. If the problem is corrected, replace A/C control Module and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Check for short to battery in harness. ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure. |
