Many malfunctions in the electrical system are caused by poor connection. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Go to next procedure.

Ignition "OFF"

Disconnect auto defogger actuator and A/C control Module main harness connector.

Measure resistance between OPEN terminal of auto defogger actuator harness connector and OPEN terminal of A/C control Module harness connector.

Measure resistance between CLOSE terminal of auto defogger actuator harness connector and CLOSE terminal of A/C control Module harness connector.

Is the measured resistance within specification?

	▶ Go to Next procedure.
	▶ Check for open in harness. ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.

Ignition "OFF"

Disconnect auto defogger actuator and A/C control Module main harness connector.

Measure resistance between OPEN terminal of auto defogger actuator harness connector and chassis ground .

Measure resistance between CLOSE terminal of auto defogger actuator harness connector and chassis ground.

Is the measured resistance within specification?

	▶ Go to Next procedure.
	▶ Check for short to ground in control harness. ▶ Repair as necessary and then go to "Verification of Vehicle Repair" procedure.