3.
Has a problem been found?
 | ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Power Circuit Inspection" Procedure. |
Many malfunctions in the electrical system are caused by poor connection. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage.
Has a problem been found?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Power Circuit Inspection" Procedure. |
Ignition "OFF"
Disconnect the Interior Antenna
Is the measured value within specifications?
| ▶ Go to "Ground Circuit Inspection" Procedure. |
| ▶ Check the open or short of the Power cirucit. And then go to "Verification of vehicle Repair" procedure. |
Ignition "OFF"
Disconnect the Interior Antenna
Is the measured value within specifications?
| ▶ Substitute with a known-good Sampe of Interior Antenna #2 and check for proper operation. If problem is corrected, replace Interior Antenna #2 and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Check the open of the ground cirucit. And then go to "Verification of vehicle Repair" procedure. |
