Component Inspection
1.

IG "OFF".

2.

IG "ON".

3.

Connect GDS and select "Diagnostic Trouble Codes(DTC)" mode.

4.

Using a GDS, Clear DTC.

5.

Select "Diagnostic Trouble Codes(DTC)" mode again.

6.

Are any DTCs present ?

▶ The main cause of this code is that improper CAN signal (Gear R) from Cluster system is detected.

▶ Check DTCs in Cluster system. If there is a code in Cluster system, repair according to DTC diagonositic guide of Cluster system.

▶ Fault is intermittent caused by poor connection in CAN signal harness and/or HECU's connector. Go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика