Are any DTCs present?
 | ▶ Go to step 1 of the component inspection and disconnect another ECU's connector which is connected to CAN Bus in step 5. ▶ Repeat above step until test completed on all ECU in CAN bus. ▶ If DTC is present after above test, Substitute with a known-good SRSCM and check for proper operation. If problem is corrected, replace SRSCM and then go to "Verification of Vehicle Repair" procedure. note ※ In a case of replacing the SRSCM, follow the replacement procedure of the DTC B1620(Internal fault-Replace SRSCM) of the SRSCM, and then perform "Longitudinal G sensor Calibration" in “Vehicle S/W Management” menu of the GDS. (DBC/HAC only, refer to C128504) |
 | ▶ Fault is intermittent caused by poor connection in IMU(SRSCM) harness or faulty IMU(SRSCM). Go to "Verification of Vehicle Repair" procedure |
