Even though G sensor replacement is detected, zero-setting is not done, a failure is recognized.
Item | Detecting Condition | Possible cause |
DTC Strategy |
•
The calibration state of the sensor monitoring | 1. Uncalibrated longitudinal G sensor |
Enabl Conditions |
•
In case that the calibration is not performed (Calibrate with ± 1deg of slope)
•
In case that the G sensor is changed. | |
Fail Safe |
•
4WD: Inhibit the ABS/ESP(ESC)/DBC/AVH control and allow the EBD control.
•
2WD: Inhibit the DBC control. | |
MIL |
•
4WD: The ABS/ESP(ESC)/DBC/AVH warning lamp is activated.
•
2WD: the ESP(ESC) warning lamp is activated. (In case DBC w/lamp exists, the DBC warning lamp is activated) | |
Reset Condition |
•
Sensor calibration is confirmed after IG turned On again - DTC is cleared and warning lamp is off after calibration is done |
