Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary, go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Power Circuit Inspection" as below.

IG key "OFF".

Disconnect (-) terminal of the battery.

Disconnect "SMART JUNCTION BLOCK"(SJB) connector and "FRONT FOG LAMP LH" connector.

Measure the resistance between "FRONT FOG LAMP LH" terminal of SJB harness connector and chassis ground.

Is the measured resistance within specification?

	▶ Substitute with a known-good SJB and check for proper operation. ▶ If the problem is corrected, replace SJB. ▶Go to "Verification of Vehicle Repair" procedure.
	▶ Check for short to ground in "FRONT FOG LAMP LH" circuit. ▶ Repair as necessary, go to "Verification of Vehicle Repair" procedure.