3.
Monitor the “Current Data” to "ECU, KEY and Smartra STATUS' Parameter on the GDS.
Specification : 'LEARNT'
Fig.1) This data show that 2 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.
Connect scantool to Data Link Connector(DLC).
IG "ON" & Engine "OFF"
Monitor the “Current Data” to "ECU, KEY and Smartra STATUS' Parameter on the GDS.
Specification : 'LEARNT'
Fig.1) This data show that 2 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.
Have the both "ECM, KEY and Smartra STATUS' been learnt ?
 | ▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the ECM or SMARTRA. And has not erased this DTC which is not erased previous repair. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Check for open or short in antenna coil.Substitute with a known-good antenna Coil and check for proper operation. and then go to "Verification of Vehicle Repair" procedure. |
